perfSONAR User Q&A and Other Discussion

[Gaetano Vocca <>]

Hi Ivan,

thank you for your kind answer, I will follow the informatiom below.

 

Best regards

Gaetano

 

Da: Garnizov, Ivan (RRZE) [mailto:]
Inviato: giovedì 29 gennaio 2015 15:24
A: Gaetano Vocca;
Oggetto: RE: [perfsonar-user] Port forwarding

 

Hi Gaetano,

 

Besides the port ranges, you will need to have the port of bwctl daemon 4823.

 

Here is the proper information about firewalling http://www.perfsonar.net/deploy/security-considerations/

And specifically on your inquiry:

 

BWCTL	TCP	4823	Incoming/Outgoing
	TCP/UDP	Edit /etc/bwctld/bwctld.conf, set peer_port to a range of values, open the TCP port for these values. It is recommended that 6001-6200 be used for this variable.
	TCP/UDP	(N.B. These instructions apply to v1.5.2 and greater of BWCT). Edit /etc/bwctld/bwctld.conf and set 'test_port' to a specific range, and open the TCP/UDP ports for those ranges. It is recommended that 5001-5900 be used.

 

And if you need to be able to perform measurements through a web UI, you should forward the TCP 443 port and/or TCP 8090 also.

 

Best regards,

Ivan

 

 

 

 

 

From: [] On Behalf Of Gaetano Vocca
Sent: Thursday, January 29, 2015 9:51 AM
To:
Subject: [perfsonar-user] Port forwarding

 

Dear all,

supposing I want to configure a bwctl node behind a router, which ports should I forward?

Currently the bwctld.conf contains the following lines

 

peer_port 6001-6200

test_port 5001-5900

 

I assume these are the port ranges that I should insert in the proper port forwarding section of the router configuration, as well as the 4823 which is the main control port.

Am I correct?

 

Thank you for your patience

Gaetano