Skip to Content.
Sympa Menu

perfsonar-user - Re: [perfsonar-user] updated owamp RPMs released

Subject: perfSONAR User Q&A and Other Discussion

List archive

Re: [perfsonar-user] updated owamp RPMs released


Chronological Thread 
  • From: Amit Khare <>
  • To: Aaron Brown <>, Lixin Liu <>
  • Cc: perfsonar-user <>
  • Subject: Re: [perfsonar-user] updated owamp RPMs released
  • Date: Thu, 5 Jun 2014 16:46:33 +0000
  • Accept-language: en-US

Hi Aaron,

We have encounter the same issue as Lixin after the upgrade. If I restart bwctld and owampd services, tests become bidirectional for few mins only. It’s the same behaviour on all our perfSONAR nodes. Please refer to the link below. Thanks,

Amit 
  
----------------------------------------------------------------------------
Amit Khare | Network Engineer | CANARIE Inc | 45 O'Connor St., Suite 500, Ottawa, ON K1P 1A4 |  Office: 613-943-5377│Cell: 613-404-8696CANARIE NOC: 613-944-5612│www.canarie.ca


From: Aaron Brown <>
Date: Thursday, June 5, 2014 at 12:30 PM
To: Lixin Liu <>
Cc: perfsonar-user <>
Subject: Re: [perfsonar-user] updated owamp RPMs released

Hey Lixin,

This update shouldn’t have changed that. Is it still the case?

Cheers,
Aaron

On Jun 4, 2014, at 1:35 PM, Lixin Liu <> wrote:

Hi Aaron,
 
I updated all our perfSONAR hosts yesterday. Since then, all latency
hosts are doing one direction tests only. Is there anything else I
should add in the OWAMP config file?
 
Thanks,
 
Lixin.
 
From:  [] On Behalf Of Aaron Brown
Sent: June-03-14 9:54 AM
To: perfsonar-user
Subject: [perfsonar-user] updated owamp RPMs released
 
Hi all,

A new set of OWAMP RPMs is now available. The OWAMP 3.4-8 RPMs are a minor bugfix release that fixes an issue where sites were incorrectly seeing very large one-way delay numbers.

Those who are using the perfSONAR Toolkit, or otherwise have the Internet2 RPM repository enabled, can run 'yum update' to get the latest changes. For those who prefer to install the RPMs manually, the newest version can be downloaded from http://software.internet2.edu/ . After installation, you will need to restart bwctld to use the new features. You can do this by running “/etc/init.d/bwctld restart”.

Please let us know if you have any questions and we look forward to everyone's continued feedback and support!

Thank you,
The perfSONAR-PS Development Team




Archive powered by MHonArc 2.6.16.

Top of Page