perfSONAR User Q&A and Other Discussion

[Aaron Brown <>]

Hi,

Could you send the output of “ps auxw”, along with /opt/perfsonar_ps/perfsonarbuoy_ma/etc/owmesh.conf from host B?

Cheers,

Aaron

On Sep 25, 2014, at 10:59 AM, Zhi-Wei Lu <> wrote:

It was the production version of 3.3 something.  Thank you.

 

Zhi-Wei Lu

IET-CR-Network Operations Center

University of California, Davis

(530) 752-0155

 

From: Daniel Doyle [] 
Sent: Thursday, September 25, 2014 7:44 AM
To: Zhi-Wei Lu
Cc: 
Subject: Re: [perfsonar-user] web GUI shows uni-directional throughput

 

Hi Zhi-Wei,

 

Are you using the 3.4 RC release or an earlier version? The GUI and backend for this has changed considerably in the 3.4 version so it would help to know which one to look at when debugging. Judging by your remark of data in the database table I am guessing pre 3.4 but wanted to double check.

 

Thanks,

-Dan

 

On Sep 24, 2014, at 11:48 AM, Zhi-Wei Lu <> wrote:

Hi all,

 

We have a few perfsonar nodes and we configure band width tests between them.  Let us call hosts A and B,  on both hosts we configured BW test between them.  On host A, we see throughput between A and B on both direction, however, on host B, I only see GUI display of Src-Dst, not Dst-Src throughput.  We did change the FQDN of host B (kept the same IP), the old name is a CNAME to the new FQDN for host B.

 

If I manually run “bwctl -s A” and ”bwctl –c A”  from host B, the tests work just fine. It appears that the data in the database table appears to be just fine (bwctl.201409_DATA). 

 

Thank you for your suggestions to fix this issue.

 

Zhi-Wei Lu

IET-CR-Network Operations Center

University of California, Davis

(530) 752-0155

 

Dan Doyle

GlobalNOC Software Developer

1-812-856-3892