Megaconference

[David Vrtin <>]

Mark, if ssh is not enabled, try telnet.

# ssh
[...]
Password:
Welcome to xxx
TANDBERG Codec Release TC6.2.0.20b1616
SW Release Date: 2013-07-02

OK

or:

# ssh
Password:
[xxx:~] $ uname -a
Linux xxx 3.7.10-226 #1 PREEMPT Mon Jul 1 18:36:11 CEST 2013 ppc GNU/Linux

Best regards,
David

On 9.10.2013 23:52, Koorus Bookan wrote:

Have you tried to ssh into it? usually, by default ssh is enabled.

See this document, on page 105 it explains the xcommands for applying release keys.

http://www.cisco.com/en/US/docs/telepresence/endpoint/codec-c-series/tc5/api_reference_guide/codec_c60-c40_api_reference_guide_tc51.pdf

The above is for V5.1 but I doubt if the commands have changed.

If ssh is not ON, then you have to hookup some kind of hyper terminal directly to its data port, and apply xcommands that way.

The good news some day you will make it work again:-)

koorus


On 09/10/2013 5:08 PM, Leonard, Mark wrote:

The subject line sounds a bit like a movie title…

Hello Megalisters--

I just did what seemed like a perfect version update of my couple year old Cisco C-40 to TC 6.0.1v … The codec did a re-boot… it informed me that the camera was getting updated…

But now it is asking for a 'valid key' (which I have) BUT the codec will not allow me access to the admin settings to enter any keys via the remote control -AND- I can no longer access the codec via HTTPS… Bricked-– (it does seem that the static IP that it had before the update is still in the codec)

I am working with my Cisco service provider but thought I would post my dilemma to the list as well… 

Thanks for looking at this-

~Mark

Mark Leonard

Media & Collaboration, UNH IT