perfSONAR User Q&A and Other Discussion

[Brian Tierney <>]

Looks like you have a very asymmetric route, and a MTU issue in 1 direction.

>bwtraceroute -T tracepath -c perfsonar-bandwidth.esc.qmul.ac.uk -s 141.163.170.165

bwtraceroute: Using tool: tracepath

bwtraceroute: 17 seconds until test results available

SENDER START

 1?: [LOCALHOST]     pmtu 1400

 1:  141.163.170.253 (141.163.170.253)                      0.484ms 

 1:  141.163.170.253 (141.163.170.253)                      2.269ms 

 2:  172.16.0.33 (172.16.0.33)                              0.418ms 

 3:  

SENDER END

>bwtraceroute -T tracepath -s perfsonar-bandwidth.esc.qmul.ac.uk -c 141.163.170.165

bwtraceroute: Using tool: tracepath

bwtraceroute: 18 seconds until test results available

SENDER START

 1?: [LOCALHOST]     pmtu 9000

 1:  MEPP3CSW01.Vlan843.ACCB.sd02-vrf-internet.core-net.qmul.ac.uk (194.36.11.3)   0.745ms 

 1:  MEPP3CSW01.Vlan843.ACCB.sd02-vrf-internet.core-net.qmul.ac.uk (194.36.11.3)  10.980ms 

 2:  146.97.143.209 (146.97.143.209)                        1.352ms 

 3:  ae25.londtw-sbr1.ja.net (146.97.35.213)                1.404ms 

 4:  ae30.londpg-sbr2.ja.net (146.97.33.5)                  1.898ms 

 5:  ae0.briswe-rbr1.ja.net (146.97.37.202)                 3.935ms 

 6:  xe-0-0-0.plymup-rbr1.ja.net (146.97.67.74)             6.733ms 

 7:  xe-0-0-0.plymup-rbr1.ja.net (146.97.67.74)             6.721ms pmtu 1500

 7:  

SENDER END

On Tue, May 24, 2016 at 8:56 AM, <> wrote:

Hello

I installed a perfsonar server and I've been facing similar problems with
bandwidth measurement, see below. I also set the MTU to different sizes (the
test below is with MTU=1400), but that did not seem to make a difference.
Occasionally, the tests do actually succeed (although the reported speed is
rather low - around 200Mbps for a Gb network and uplink).

Any thoughts about what could be the problem?

Best regards
Bogdan

----

bwctl -T iperf3 -t 10 -O 4 -v -x -c "perfsonar-bandwidth.esc.qmul.ac.uk:4823"
Messages being sent to syslog(user,err)
bwctl: Using 141.163.170.165 as the address for local sender
bwctl: Using perfsonar-bandwidth.esc.qmul.ac.uk:4823 as the address for remote
receiver
bwctl: Available in-common: iperf nuttcp iperf3
bwctl: Using tool: iperf3
bwctl: Server 'perfsonar-bandwidth.esc.qmul.ac.uk:4823' accepted test request
at time 1464087718.423526
bwctl: Client 'localhost' accepted test request at time 1464087735.082031
bwctl: Tests accepted at different times re-requesting test with new time
bwctl: Server 'perfsonar-bandwidth.esc.qmul.ac.uk:4823' accepted test request
at time 1464087740.078125
bwctl: Client 'localhost' accepted test request at time 1464087740.078125

RECEIVER START
bwctl: start_endpoint: 3673076511.268639
bwctl: run_endpoint: receiver: 194.36.11.37
bwctl: run_endpoint: sender: 141.163.170.165
bwctl: exec_line: iperf3 -s -1 -B 194.36.11.37 -f m -p 5656 -V
bwctl: run_tool: tester: iperf3
bwctl: run_tool: receiver: 194.36.11.37
bwctl: run_tool: sender: 141.163.170.165
bwctl: start_tool: 3673076537.000126
iperf 3.1.2
Linux perfsonar-bandwidth.esc.qmul.ac.uk 2.6.32-573.26.1.el6.web100.x86_64 #1
SMP Fri May 6 11:17:16 PDT 2016 x86_64
-----------------------------------------------------------
Server listening on 5656
-----------------------------------------------------------
Time: Tue, 24 May 2016 11:02:20 GMT
Accepted connection from 141.163.170.165, port 47577
     Cookie: localhost.localdomain.1464087740.079
     TCP MSS: 1368 (default)
[ 16] local 194.36.11.37 port 5656 connected to 141.163.170.165 port 47616
Starting Test: protocol: TCP, 1 streams, 131072 byte blocks, omitting 4
seconds, 10 second test
[ ID] Interval           Transfer     Bandwidth
[ 16]   0.00-1.00   sec  8.23 MBytes  69.0 Mbits/sec
(omitted)
[ 16]   1.00-2.00   sec  0.00 Bytes  0.00 Mbits/sec                  (omitted)
[ 16]   2.00-3.00   sec  0.00 Bytes  0.00 Mbits/sec                  (omitted)
[ 16]   3.00-4.00   sec  0.00 Bytes  0.00 Mbits/sec                  (omitted)
[ 16]   0.00-1.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   1.00-2.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   2.00-3.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   3.00-4.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   4.00-5.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   5.00-6.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   6.00-7.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   7.00-8.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   8.00-9.00   sec  0.00 Bytes  0.00 Mbits/sec
[ 16]   9.00-10.00  sec  0.00 Bytes  0.00 Mbits/sec
[ 16]  10.00-10.04  sec  0.00 Bytes  0.00 Mbits/sec
- - - - - - - - - - - - - - - - - - - - - - - - -
Test Complete. Summary Results:
[ ID] Interval           Transfer     Bandwidth
[ 16]   0.00-10.04  sec  0.00 Bytes  0.00 Mbits/sec                  sender
[ 16]   0.00-10.04  sec  0.00 Bytes  0.00 Mbits/sec                  receiver
CPU Utilization: local/receiver 0.1% (0.0%u/0.2%s), remote/sender 0.0%
(0.0%u/0.0%s)
bwctl: stop_tool: 3673076554.303890
bwctl: stop_endpoint: 3673076554.303890

RECEIVER END

SENDER START
bwctl: start_endpoint: 3673076511.272606
bwctl: run_endpoint: receiver: 194.36.11.37
bwctl: run_endpoint: sender: 141.163.170.165
bwctl: exec_line: iperf3 -c 194.36.11.37 -B 141.163.170.165 -f m -p 5656 -V -Z
--omit 4 -t 10
bwctl: run_tool: tester: iperf3
bwctl: run_tool: receiver: 194.36.11.37
bwctl: run_tool: sender: 141.163.170.165
bwctl: start_tool: 3673076540.078318
iperf 3.1.2
Linux localhost.localdomain 2.6.32-573.26.1.el6.x86_64 #1 SMP Wed May 4
00:57:44 UTC 2016 x86_64
Time: Tue, 24 May 2016 11:02:20 GMT
Connecting to host 194.36.11.37, port 5656
     Cookie: localhost.localdomain.1464087740.079
     TCP MSS: 1368 (default)
[ 15] local 141.163.170.165 port 47616 connected to 194.36.11.37 port 5656
Starting Test: protocol: TCP, 1 streams, 131072 byte blocks, omitting 4
seconds, 10 second test
[ ID] Interval           Transfer     Bandwidth       Retr  Cwnd
[ 15]   0.00-1.00   sec  11.0 MBytes  92.4 Mbits/sec    2   1.62 MBytes
(omitted)
[ 15]   1.00-2.00   sec  0.00 Bytes  0.00 Mbits/sec    1   1.62 MBytes
(omitted)
[ 15]   2.00-3.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
(omitted)
[ 15]   3.00-4.00   sec  0.00 Bytes  0.00 Mbits/sec    1   1.62 MBytes
(omitted)
[ 15]   0.00-1.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   1.00-2.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   2.00-3.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   3.00-4.00   sec  0.00 Bytes  0.00 Mbits/sec    1   1.62 MBytes
[ 15]   4.00-5.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   5.00-6.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   6.00-7.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   7.00-8.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   8.00-9.00   sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
[ 15]   9.00-10.00  sec  0.00 Bytes  0.00 Mbits/sec    0   1.62 MBytes
- - - - - - - - - - - - - - - - - - - - - - - - -
Test Complete. Summary Results:
[ ID] Interval           Transfer     Bandwidth       Retr
[ 15]   0.00-10.00  sec  0.00 Bytes  0.00 Mbits/sec    1             sender
[ 15]   0.00-10.00  sec  0.00 Bytes  0.00 Mbits/sec                  receiver
CPU Utilization: local/sender 0.2% (0.1%u/0.2%s), remote/receiver 0.1%
(0.0%u/0.2%s)

iperf Done.
bwctl: stop_tool: 3673076554.301276
bwctl: stop_endpoint: 3673076554.301276

SENDER END

---

--

Brian Tierney, http://www.es.net/tierney
Energy Sciences Network (ESnet), Berkeley National Lab
http://fasterdata.es.net