Skip to Content.
Sympa Menu

perfsonar-user - Re: [perfsonar-user] Re: Can you provide more information on setting up host server and ntp sync?

Subject: perfSONAR User Q&A and Other Discussion

List archive

Re: [perfsonar-user] Re: Can you provide more information on setting up host server and ntp sync?


Chronological Thread 
  • From: Hao Bai <>
  • To: Szymon Trocha <>
  • Cc: Andrew Lake <>, "" <>, Brian Tierney <>, Nasir Ghani <>
  • Subject: Re: [perfsonar-user] Re: Can you provide more information on setting up host server and ntp sync?
  • Date: Fri, 20 May 2016 12:07:27 -0400

Hi Szymon:

Thank you for your reply. 

I believe I installed all the perfsonar bundles, including testpoint, core and toolkit, just not through netinstall or fullinstall.
The reason I did this, is the VM I was using is from other department and a basic centOS 6.7 is pre-installed.

I am wondering now, if the full/net install will have some steps setting up hostname or it is setup automatically.

Thanks.

--Hao

On Fri, May 20, 2016 at 6:20 AM, Szymon Trocha <> wrote:
Hi Hao,

W dniu 19.05.2016 o 21:26, Hao Bai pisze:
Hi Andrew:

Thank you for your quick reply. 

For the NTP synchronization, you mean it will be synchronized automatically as long as the service is running?
The NTP unsynchronized is shown when I start up the bwctl/owamp service as below.

Yes, you may have to wait a bit after NTP synchronizes properly your host and that's why you got the warning. You may see the results with ntpq -p command.

Inline image 2



And from the setting up page below, my understanding is I need to configure hostname (domain) and interface so that I can start web interfaces.

Which bundle did you install? The Web interface is included in perfsonar-toolkit bundle. See http://www.perfsonar.net/about/where-can-it-be-downloaded/
You will not be able to access it if it wasn't installed.

Am I correct on this? Or it is set up as the IP address automatically, or where did I setup such information?
On either case I cannot access the web interface right now. 
Also, in my configuration file, I did not see such lines as setting up primary interface, but I guess it will be setup as eth0 at default.

Inline image 1



I think it would be much easier for you to start from scratch if possible and simply install perfsonar-toolkit bundle. You should then get everything you expect.

Is there any particular reason you didn't use the full or netinstall option?

Regards,

-- 
Szymon Trocha

Poznań Supercomputing & Netw. Center ::: NETWORK OPERATION CENTER
Tel. +48 618582022 ::: http://noc.man.poznan.pl




Archive powered by MHonArc 2.6.16.

Top of Page