perfSONAR User Q&A and Other Discussion

["Garnizov, Ivan (RRZE)" <>]

Hi guys,

 

  I would like also to support this feature request!

 

Best regards,

Ivan

 

From: [mailto:] On Behalf Of Zhi-Wei Lu
Sent: Saturday, May 02, 2015 6:08 PM
To: Aaron Brown
Cc: Brian Tierney;
Subject: Re: [perfsonar-user] bwctld.conf src_node syntax for multiple interfaces and ipv4 and ipv6

 

Hi Aaron,

I enabled bwctl on all interfaces now and use iptable and ip6table hack to filter for certain interface.

Let me know when the option will be available so that I don't have to remember updating iptable rules for every perfSONAR update.

Thank you.

On 05/01/2015 01:51 PM, Aaron Brown wrote:

Hi,

 

Unfortunately, the bwctl configuration syntax doesn’t support this mode. You may be able to work around it by defining a hostname in /etc/hosts that has both the v4 and v6 address for that interface, and telling bwctld to use it.

 

Cheers,

Aaron

 

On Apr 30, 2015, at 12:11 PM, Zhi-Wei Lu <> wrote:

 

Hi Brian,

 

This is the daemon configuration, right now I can only enable the daemon to listen on v4 or v6, but not both.  I can make out-bound bwctl run on either v4 or v6.

I only want to enable on one interface, otherwise, by default, bwctld will listen on all interfaces and on v4 and v6.

 

Thank you.

 

Zhi-Wei Lu

IET-CR-Network Operations Center

University of California, Davis

(530) 752-0155

 

From: Brian Tierney [] 
Sent: Thursday, April 30, 2015 8:32 AM
To: Zhi-Wei Lu
Cc: 
Subject: Re: [perfsonar-user] bwctld.conf src_node syntax for multiple interfaces and ipv4 and ipv6

 

 

The tests will default to V6, but you should be able to do a V4 test by using the bwctl -4 flag.

Did you try that?

Sent from my tablet device

On Apr 29, 2015, at 6:58 PM, Zhi-Wei Lu <> wrote:

Hi all,

 

I have a two NIC perfSONAR node, one NIC is used for owamp, while the other was used for bw only.  Therefore, I have a very simple bwctld.conf file as follows:

 

log_location

src_node        ipv4-address:4823

#src_node [ipv6-address]:4823

peer_port       6001-6200

facility        local5

group   bwctl

nuttcp_port     5301-5600

owamp_port      5601-5900

iperf_port      5001-5300

user    bwctl

 

This works only for the ipv4 address on one interface, now I would like to make ipv6 test available.  I thought that I might be able to add a line below the ipv4, simply by adding the ipv6 address in the configuration above (with # at the moment).  If remove #

#src_node [ipv6-address]:4823

Restart bwctld, only ipv6 test is available.  How could I make both ipv4 and ipv6 tests available on the same NIC?  I would really appreciate if someone could guide me to the right direction. 

 

Thank you.

 

Zhi-Wei Lu

IET-CR-Network Operations Center

University of California, Davis

(530) 752-0155

 

-- 

Zhi-Wei Lu

IET-CR-Network Operations Center

University of California, Davis

(530) 752-0155