perfSONAR User Q&A and Other Discussion

[KENNETH D MILLER II <>]

Thanks Aaron.  Thats what I was afraid of.  I thought that might be the case. 
 Does the ssh login prompt query the lookup service as well?
"
The web interface should be available at:

https://[host address]/toolkit
"
We're looking to upgrade our internal 35 or so nodes across the state to 3.4 
and were looking at running an internal lookup service for our state wide 
measurement setup.  This has been very helpful in holding vendors 
accountable.  Has there been any new documentation on an internal lookup 
service?

For Border, Science DMZ, and other research spots, we will have public IPs 
and operate normally.

Thanks,
Ken

----- Original Message -----
> From: "Aaron Brown" 
> <>
> To: "KENNETH D MILLER II" 
> <>
> Cc: 
> 
> Sent: Tuesday, February 10, 2015 9:33:54 AM
> Subject: Re: [perfsonar-user] public vs private IPs
> 
> Hey Ken,
> 
> Unfortunately, that’s all grabbed from the lookup services. You may be able
> to get it working with a private LS, but I’m not sure the specifics on what
> you’d need to do beyond install the lookup-service RPM, and point the LS
> registration daemons at it. There may need to be some changes in the graph
> configuration too to point at that new LS.
> 
> Cheers,
> Aaron
> 
> > On Feb 10, 2015, at 9:07 AM, KENNETH D MILLER II 
> > <>
> >  wrote:
> > 
> > Hi all,
> > 
> > I'm using the ps-toolkit with OWAMP to test between 3 sites.  I currently
> > have them all configured with private IPs, RFC1918.  I have already update
> > the web_admin.conf file for private addresses.  However the capacity and
> > MTU are not showing up.  How do I get them to appear?
> > 
> > When I built these machines on public, everything worked ok.  Is there a
> > list of what services work on public vs private IP space?
> > 
> > 
> > 
> > Thanks,
> > Ken
> > <20150210 PSU-Philly-Comcast.png>
> 
>