perfSONAR User Q&A and Other Discussion

[Szymon Trocha <>]

W dniu 14.01.2018 o 23:26, 

 pisze:
> Hi guys,
>
> I have 2 perfsonars that was configured with IPV4 only and all tests are going
> well.
> After 1 week ago they received IPV6 addresses/tests, but they still showing
> only IPV4 results.
>
> - My host information shows my IPV4 and IPV6 respective addresses;
> - In tested hosts that have IPV6 set, they show their respective addresses;
> - I can ping6 these hosts.
>
> In my test list, one mesh has IPV6 check box marked and even setting some
> tests to IPV6 hosts by hand, they doesn't show in my PerfSonar Test Results.
>
> I've been searching all docs and mail lists but I could not find an answer for
> that behavior.
>
> Thanks in advance.
>
> E Junior

Hi E Junior,

Just to eliminate obvious things - don't you have more than 10 tests so 
that not all of them are immediately displayed in the main page? So you 
need to go to the next page to find more

Regards,

--
Szymon Trocha

Poznań Supercomputing & Networking Center
Tel. +48 618582022 ::: http://noc.pcss.pl