perfSONAR User Q&A and Other Discussion

["Liu, Dengfeng (NIH/CIT) [C]" <>]

Andy;

I reran the meshconfig-guiagent and set skip-table-built to 0, the https mostly working except the test result for report range of "1 week" not show up.

The problem I just noticed that the test result now shows over 10Gb/s(like 15gb/s), which is correct 'cause we have 10G NIC only.

Thanks

Dengfeng

---

From: <> on behalf of Andrew Lake <>
Sent: Tuesday, May 2, 2017 9:13 AM
To: Liu, Dengfeng (NIH/CIT) [C]; perfsonar-user
Subject: Re: [perfsonar-user] maddash dashboard not clickable when using https

 

Sorry, hit send too soon. From my email last week (you were also asking about some other errors so may have missed this part), did you check the following:

When you click on a box does it load everything except the graph? My best guess is because the graph is using an http URL and the browser doesn't like it when you mix http and https. By default it should be using a relative URL of /perfsonar-graphs/ which should keep things consistent. Have you by chance set graph_url any place (it may be multiple places) in /etc/perfsonar/meshconfig-guiagent.conf? If so, you can delete it or comment it out. You may have to wait for the checks to run again for the change to take effect, so it might not happen right away. If you have not set graph_url, I am not quite sure why it won’t load.

Thanks,

Andy

On May 2, 2017 at 9:11:40 AM, Andrew Lake () wrote:

Hi,

From my email last week (youw ere also asking about some other errors so may have missed this part), did you check the following:

On May 2, 2017 at 8:21:11 AM, Liu, Dengfeng (NIH/CIT) [C] () wrote:

When I use https to access madash, the test result block is not clickable, and also the MENU is missing, but when using http everything working fine.

Anyone experience this?
( I am upgrading from 3.5.2 ISO install).

Dengfeng