perfsonar development work

["Stijn Verstichel" <>]

Hi Szymon,

Stijn (the other one) is doing curent active development. And he's on annual
leave at the moment, so I cannot ask him to get a definite answer. But I'm
rather sure that this (see below) is what the purpose of this set is. It was
discussed on the list and in several meeting before that it would be
beneficial if there would be the possibility of choosing a pre-defined set
of commands. An Excel table was mailed around with the commands and their
translation in the different command-specific syntaxes for cisco and
juniper. 

Regardsm

Stijn

-- 
Stijn Verstichel 
<>
G. Crommenlaan 8/201,
9050, Ghent
Belgium
Tel: +32 9 33 14 981
Fax: +32 9 33 14 899
Department of Information Technology
Ghent University - IBCN - IBBT
www.ibcn.intec.ugent.be - www.ibbt.be 
-----Original Message-----
From: Szymon Trocha 
[mailto:]
 
Sent: dinsdag 4 september 2007 10:20
To: perfsonar-dev
Subject: [pS-dev] [Fwd: Default set of command for SSH/Telnet MP]

Does somebody know teh answer?
Sz.

-------- Original Message --------
Subject: Default set of command for SSH/Telnet MP
Date: Mon, 03 Sep 2007 13:18:33 +0200
From: Szymon Trocha 
<>
To: MDM pilot 
<>

Hi,

What's the default set of commands applied in installation step "A
predefined set of minimum commands is provided. Do you wish to
  use this set or do you want to build a custom set? (yes/no)" ?

I guess this is a preferred set by MDM ?

Regards,
--
Szymon Trocha

Poznan Supercomputing & Ntw. Center ::: NETWORK OPERATION CENTER Tel. (+48
61) 8582022 http://noc.man.poznan.pl  ::: http://noc.pionier.gov.pl